POSline SM2430 Especificações Página 1

Manual del UsuarioSM2430ESPECIFICACIONES SUJETAS A CAMBIO SIN PREVIO AVISO.

64. Move the scanner into position on the mounting plate, engaging the tab on the underside. Be careful not to pinch the cable.Figure 3: Install Scann

7Auxiliary Handheld Scanner Connection (optional)The scanner supports the operation of an auxiliary handheld scanner, which may be connected via a 10-

84.4 Connecting to the HostThe power link interface cable comes with different host-end connectors, depending on the host. Follow the steps below to

9Programming Guide, to the scanner. The scanner gives two beeps: low and high, and the LED turns red. The scanner is in programming mode.2. Decide whi

106 OperationThe scanner can read barcodes in either sweep or presentation mode to accommodate different requirements. Sweep mode means moving items

116.2 BeepsA beeper gives audible feedback on scanner operation. 6.3 Changing the Beep VolumeThe scanner can be programmed with the Programming Guid

126.5 Controlling the Scanner from a POS SystemThe scanner can be controlled from the POS system via the RS-232C interface. Control can be accomplish

137 Maintaining the ScannerThe scanner is designed for long-term trouble-free operation and rarely needs any maintenance. Only an occasional cleanin

148 SpecificationsOPERATIONALLight Source Dual 650nm visible laser diodesDepth of Scan Field 0-216mmWidth of Scan Field 90mm @ contact, 218mm @ 216m

15ENVIRONMENTOperating Temperature 0°C - 40°CStorage Temperature -20°C - 60°CHumidity 5% - 95% RH (non-condensing)Light Level max. 4000 LUX (fluoresce

iNo warranty of any kind is made in regard to this material, including, but not limited to, implied warranties of merchantability or fitness for a par

16Figure 5: Scan Fieldtop viewside view

1710 Pin AssignmentsConnecting Ports HOST PortPin Connector TypeKeyboard Wedge RS-232C1 DC + 5 V input2 Keyboard Clock N.C.3 PC Clock RTS_CMOS

1811 Troubleshooting Problem Diagnostic TipsThe scanner is on but cannot read barcodes. The LED stays blue.The scanner window is dirty. Clean the s

19Problem Diagnostic TipsA barcode is read by the scanner but not accepted by the POS system.The communication cable is not connected to the correct p

20Notes

21Figure 6: Mounting Plate Boring Template

iiLaser SafetyThe Dual-Laser Omnidirectional Vertical Scanner complies with safety standard IEC 60825 for a Class I laser product. It also complies wi

iiiTable of Contents1 Introduction... 12 Unpacking...

11 IntroductionThis advanced scanner is a proud to be among the world's first dual-laser pre-sentation scanners, and it incorporates numerous r

23 Finding Your Way Around Figure 1: Overview4 Connecting and Mounting4.1 PowerThe scanner requires a minimum of 300mA at 5 Vdc power. The interf

3are sure your POS system can handle the load, it is recommended that you use the supplied power adapter. When an external adapter is connected, the s

42. Insert the 8-pin modular plug of the power link cable into the “host” connec-tor in the back of the scanner until a firm click is heard. 3. Plug t

5Mounting Plate Installation1. Position the mounting plate in the desired location and secure it in place. If desired, use the full-size boring templa