POSline SM2430 Especificações descarregar pdf (Página 10)

ADVANCED PROGRAMMING GUIDE

2. CHANGE THE SCANNER SETTING

In order to change the scanner setting, please follow the steps below:

1. Scan the “Enter/Exit Programming Mode” barcode, there will be 2 beeps

(low-high) indicating ready to make settings.

2. Scan barcodes for the desired feature (1 beep)

3. Scan the “Enter/Exit Programming Mode” barcode again to save the

configuration, there will be 2 beeps (long---short) indicating settings

successfully.

After reading a valid barcode in programming mode the scanner will gave a high

beep.

3. DEFAULT PARAMETERS

This table gives the default settings of all the programmable parameters. The

default settings will be restored whenever the "Reset" programming label is

scanned and the laser scanner is in programming.

Default Values of Operating Parameters

Function Default

Sleep mode

Motor sleep mode After 30 minutes

Laser sleep mode After 10 minutes

Scanner timing

Same code delay 200msec

Beeper Tone

Frequency medium

Duration 50msec

Code Identifiers

Code ID off

Code 39 M

ITF 2 of 5 I

Chinese post code H

UPC-A A

UPC-E E

EAN-13 F

EAN-8 FF

Codabar N

Code 128 K

Code 93 L

MSI/Plessy P

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 282 283

Sem comentários

POSline SM2430 Especificações Página 10